Installing The Hard Disk Drive Cage - Lenovo NeXtScale nx360 M4 Installation And Service Manual

Pin
1.8-inch solid-state
drive cage
Pin hole
Figure 39. Removing a hard disk drive cage (1.8-inch)
Step 1. Remove the cover (see "Removing a compute node from a chassis" on page 92).
Step 2. Remove the easy-swap hard disk drives and hard disk drive bay fillers (see "Removing and
installing drives" on page 142).
Step 3. Remove the hard disk drive backplate (see "Removing the hard disk drive backplate" on page 139).
Step 4. Using a Phillips (for 3.5-inch hard disk drive cage) T8 torx (for 2.5-inch or 1.8-inch hard disk drive
cage, provided on the back of the chassis) screwdriver, remove the screws (four for 2.5-inch hard
disk drive cage and three for 1.8-inch hard disk drive cage) from the cage and rotate the cage from
under the bezel; then, remove the cage from the compute node at an angle.
If you are instructed to return the hard disk drive cage, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Installing the hard disk drive cage

Use this information to install the hard disk drive cage.
Before you install the hard disk drive cage, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 89.
2. If the compute node is installed in an IBM NeXtScale n1200 Enclosure, remove it (see "Removing a
compute node from a chassis" on page 92 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To install the hard disk drive cage, complete the following steps.
Screws
T8 torx screwdriver
.
Chapter 5 Removing and replacing components
119