Table of Contents
Advertisement
Step 7.
Reinstall the DIMMs (see
Step 8.
Reinstall the system battery (see
Step 9.
Reinstall the microprocessor 2 and DIMM air baffles (see
on page 427
and
Step 10. Reinstall the PCI riser-card assemblies and adapters, if any were installed (see
riser-card assembly" on page
Step 11. Reinstall the virtual media key (see
Step 12. Reconnect to the system board the cables that you disconnected in
system
board".
Step 13. Install the cover (see
Step 14. Push the power supplies back into the server.
Step 15. Slide the server into the rack.
Step 16. Reconnect the power cords and any cables that you removed.
Step 17. Turn on the peripheral devices and the server.
Important:
• Start the Setup utility and reset the configuration.
– Set the system date and time.
– Set the power-on password.
– Reconfigure the server.
See
"Using the Setup utility" on page 517
• Either update the server with the latest RAID firmware or restore the pre-existing firmware from a diskette
or CD image.
• Update the UUID (see
• Update the DMI/SMBIOS (see
System x3550 M3Problem Determination and Service Guide
512
"Installing a memory module" on page
"Installing the system battery" on page
"Installing the DIMM air baffle" on page
487).
"Installing the virtual media key" on page
"Installing the cover" on page
for details.
"Updating the Universal Unique Identifier (UUID)" on page
"Updating the DMI/SMBIOS data" on page
430).
479).
"Installing the microprocessor 2 air baffle"
428).
Step 12 in "Removing the
425).
530).
531).
"Installing a PCI
470).
Advertisement
Table of Contents
