Function
Enable
Server IP Address
Port
Sub Service ID
Click Apply to complete the settings.
Step 3
4.11.16 Setting Switch
Background Information
After setting Switch, when an IPC is connected to the PoE port, the system automatically assigns the
IP address to the IPC according to the set IP segment, and the NVR will automatically connect to the
IPC.
● Only models with PoE ports support this function.
● Do not connect the PoE port with a switch, otherwise it will cause connection failure.
● This function is enabled by default, and the IP segment start from 10.1.1.1, we recommend that
you use the default setting.
● When connecting to a third-party IPC, make sure that the IPC supports Onvif protocol and DHCP
is enabled.
Procedure
Step 1
Select Main Menu > Network > Switch.
Step 2
Set the values of IP Address, Subnet Mask and Default Gateway.
Do not set the value of IP Address to the same network segment with the NVR, we
Table 4-78
Description
Enable the register function.
Enter the server IP address or the server domain that you want to
register to.
Enter the port of the server.
This ID is allocated by the server and used for the Device.
Figure 4-235
351
User's Manual