Cluster Control; Arbitrage Ip - Dahua L Series User Manual

transfers video records from sub device when the main device is working normally. You can also
manually transfer video records from sub device to the main device.
Prerequisites
The main device works normally.
Procedure
Step 1 Select SETTING > Cluster Service > Transfer Recorder.
Step 2 Click Add Task.
Step 3 Configure parameters.
Step 4 Click OK.
You can click

5.4.5 Cluster Control

5.4.5.1 Cluster Control
Background Information
From SETTING > Cluster Service > Cluster Control, you can go to the Cluster Control interface. It
is to enable/disable cluster. See Figure 5-4.
You can see the corresponding prompt if you successfully enabled cluster service.

5.4.5.2 Arbitrage IP

Background Information
When there is only two NVRs in the cluster, you can set the arbitration IP to change the cluster
accordingly. The arbitration IP is the IP address of other device/PC/gateway that can connect to the
NVR.
From SETTING > Cluster Service > Arbitrage IP, you can see the following interface. See Figure 5-
5.
to view the transfer information.
Figure 5-4
419
User's Manual