Table of Contents
Advertisement
Step 2
Click
Step 3
Configure the parameters.
Function
Server Address
Port
Sub-Device ID
Click Apply.
Step 4
5.11.17 Switch
Background Information
After setting Switch, when an IPC is connected to the PoE port, the system automatically assigns
the IP address to the IPC according to the defined IP segment, and the NVR will automatically
connect to the IPC.
Only models with PoE ports support this function.
●
Do not connect the PoE port with a switch, otherwise it will cause connection failure.
●
This function is enabled by default, and the IP segment start from 10.1.1.1. We recommend you
●
use the default setting.
Figure 5-218 Register
to enable the function.
Table 5-67 Register parameters
Description
Enter the IP address or domain name of the server that you want to
register to.
Enter the port of the server.
Enter the ID allocated by the server.
337
User's Manual
Advertisement
Table of Contents
