Assigning Dsx-1 Time Slots To The Network Interface - Paradyne FrameSaver SLV 9124 User Manual

Configuration

Assigning DSX-1 Time Slots to the Network Interface

3-34
Procedure
1. Follow this menu selection sequence:
Main Menu Configuration
Frame Relay Network Assignments
The Frame Relay Network Assignments screen appears. This screen
contains a matrix of the current assignment status of all time slots on the
network interface.
2. Enable or disable Time Slot Discovery.
— When enabled, the unit examines all time slots not cross-connected to
other ports to determine which time slots are being used by the network
for frame relay traffic. These time slots are set to FrameRly1. This is
the factory default.
— When disabled, time slot assignments must be manually configured.
3. If Time Slot Discovery is disabled, assign network time slots for use by frame
relay service, link 1, by typing FrameRly1 in the selected Network field.
4. Repeat Step 3 until all desired time slots are assigned.
5. Save the configuration.
DSX-1 time slots are assigned by channel allocation, where you specify individual
time slots. The DSX-1 interface must be enabled to assign DSX-1 time slots to
the network interface (see Table 3-6,
Value Meaning
N tt It represents time slot tt of the selected network interface.
Assigned The time slot is already assigned to something other than a DSX-1
time slot, so it is unavailable. Assigned time slots cannot be
modified from this screen.
Available The time slot is currently unassigned.
D s - p / tt Time slot tt of DSX-1 interface p in slot s is assigned to the network
interface time slot identified right above it (N tt ).
March 2000
Time Slot Assignment
DSX-1 Physical Interface Options).
9124-A2-GB20-00