Selecting A Frame Relay Discovery Mode - Paradyne FrameSaver SLV 9124 User Manual

Selecting a Frame Relay Discovery Mode

9124-A2-GB20-00
When a Frame Relay Discovery Mode is active, the FrameSaver unit "discovers"
network DLCIs from the network LMI status response message. It configures a
network DLCI, a user data port DLCI, and automatically connects them to create
a PVC.
Main Menu Auto-Configuration
Automatically configured network DLCIs are multiplexed, and each automatically
configured port DLCI carries the same DLCI Number as its corresponding
network DLCI. These are the same DLCI numbers that would have been
available had the FrameSaver unit not been inserted in the link, between your
equipment and the network.
NOTE:
A local Management PVC (e.g., the PVC between the router and the
FrameSaver unit's user data port) must be configured manually; it cannot
be configured automatically (see
Central Site ).
The following will occur when a Frame Relay Discovery Mode is selected:
Discovery Mode
1MPort
(default)
1Port
NetOnly
Disable
March 2000
Frame Relay Discovery Mode
Setting Up Local Management at the
Configuration Description
Auto-configuration is enabled on Port-1.
A management DLCI is configured.
A multiplexed network DLCI containing two embedded
DLCIs (EDLCIs) is configured for Port-1 user data and
management data.
A PVC connection is configured between the network
and port DLCIs.
Auto-configuration is enabled on Port-1.
No management DLCI is configured.
A multiplexed network DLCI is configured for Port-1
user data.
A PVC connection is configured between the network
and port DLCIs.
Auto-configuration of a network DLCI only; no Port-1 or
PVC connections are configured.
No Port-1, PVC connection, or management DLCI is
configured.
No frame relay discovery or automatic configuration
takes place.
The FrameSaver unit will be configured manually.
Configuration
3-11