Setting Up Management; Setting Up Local Management At The Central Site - Paradyne FrameSaver SLV 9124 User Manual

Configuration

Setting Up Management

Setting Up Local Management at the Central Site

3-14
FrameSaver units are already set up for SNMP management, with Community
Name 1 set to Public and Name 1 Access set to Read/Write. For remote sites,
other than the IP Address, this is all that is required.
Configuration Management and Communication
General SNMP Management
See Table 3-13, General SNMP Management
information. For the central site, local management between the unit and the
router must be set up, as well (see Setting Up Local Management at the Central
Site ).
Set up a local management PVC between the central site unit and its router for
local management control by the end-user customer.
Procedure
To set up management through the router:
1. Create a DLCI that will be used for management on the user data port.
Configuration
2. Create a Management PVC using the user data port DLCI just created.
Configuration
Minimally, enter the following options:
— Name for the management PVC
— Interface IP Address and Subnet Mask, if different from the Node's
— Primary Link for this Management PVC (the user data port)
— Primary DLCI (i.e., the data port DLCI)
3. Save the configuration.
See Table 3-9, DLCI Record
for configuration information.
March 2000
Options, for configuration
Data Ports DLCI Records
Management and Communication
Options, and Table 3-12,
Management PVC
Management PVC Options,
9124-A2-GB20-00