Paradyne FrameSaver SLV 9124 User Manual page 158

Troubleshooting
6-8
Table 6-1. Alarm Conditions (2 of 6)
Alarm Condition What It Indicates
DLCI nnnn Down, The DLCI for the specified
1, 2
frame relay link frame relay link is down.
DTR Down from The DTR control lead on
Port-1 Device the device connected to the
specified port is off. This
message applies to data
ports that act as DCEs.
Link Down The specified frame relay
Administratively, link has been disabled by
2
frame relay link the unit due to LMI
Behavior conditions or LMI
Protocol on another link is
in a failed state.
This is not an alarm
condition so System
Operational appears,
as well.
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port-1. The frame relay link associated with the user data port.
March 2000
What To Do
Verify that the network LMI is up.
If it is, contact your network
service provider.
Examine the attached DTE and
cable connected to the system's
port.
Check that the port cable is
securely attached at both
ends.
Check the status of the
attached equipment.
Verify that the network LMI is up.
If it is, contact your network
provider.
9124-A2-GB20-00