Netscout Indexes To The Interface Table (Iftable - Paradyne FrameSaver SLV 9124 User Manual

NetScout Indexes to the Interface Table (ifTable)

For remote monitoring at sites where FrameSaver units are operating with
NetScout Probes, use the following ifName, ifDescr, and ifIndex.
9124-A2-GB20-00
Table B-2. NetScout Interface Objects Information
ifName Description
Frame Relay Logical Layer
Frame Relay 1 Frame relay logical
Network link on the network
interface
Frame Relay 3 Synchronous Data
Sync Data Port-1
Port 1
RMON Logical Layer
RMON Frame These values are
Relay Logical calculated.
Interfaces
For the DTE: For the DTE:
(ifIndex –1) * 2 +17
For the DCE: DTE
calculated value +1
RMON Virtual These values are
Interfaces calculated based on
the probe's internal
circuit index: circuit
index +65.
RMON Virtual These values are
Logical calculated.
Interfaces
For the DTE:
(virtual interface
ifIndex – 65) * 2 ifIndex – 65) * 2
+513
For the DCE:
DTE calculated
value +1
March 2000
SNMP MIBs and Traps, and RMON Alarm Defaults
ifDescr (ifEntry 2)
For the DTE side:
RMON (IN/OUT); Network T1
of FR DTE; T1 FR NAM;
Hardware Version: hhhh-hhh
For the DCE side:
RMON (IN/OUT); Network T1
of FR SERVICE; T1 FR NAM;
Hardware Version: hhhh-hhh
For the user side:
RMON (IN/OUT); Synchronous
Data Port of FR DTE, Slot: 1,
Port: 1; T1 FR NAM; Hardware
Version: hhhh-hhh
For the network side:
RMON (IN/OUT); Synchronous
Data Port of FR SERVICE,
Slot: 1, Port: 1; T1 FR NAM;
Hardware Version: hhhh-hhh
OUT – RMON (IN);
[ ifName of the interface ]
OUT – RMON (OUT);
[ ifName of the interface ]
—
IN – VIRTUAL PVC
[ interface number ]
[ DLCI number ] DTE
OUT – VIRTUAL PVC
[ interface number ]
[ DLCI number ] DCE
ifIndex
1
3
17– 48
65 – 512
513 –1023
B-5