Creating A Login - Paradyne FrameSaver SLV 9124 User Manual

Creating a Login

*
Security is enabled by the configuration options Login Required for the communication port, modem port, and
Telnet Login Required or FTP Login Required for a Telnet or FTP Session.
9124-A2-GB20-00
See Configuring SNMP NMS Security Options
more information about SNMP NMS Security configuration options.
A login is required if security is enabled.*
combinations can be created using ASCII text, and each login must have a
specified access level. Logins must be unique and they are case-sensitive.
Procedure
To create a login record:
1. Select Administer Logins.
Main Menu Control
2. Select New, and set the following configuration options, as appropriate.
In the field . . .
Login ID
Password
Re-enter password
Access Level
NOTE:
See Resetting the Unit and Restoring Communication
Troubleshooting , should you be locked out inadvertently.
3. Save your changes.
When Save is complete, the cursor is repositioned at the Login ID field, ready
for another entry.
March 2000
in Chapter 3, Configuration, for
p to six login ID/password
U
Administer Logins
Enter the . . .
ID of 1 to 10 characters.
Password from 1 to 10 characters.
Password again to verify that you entered the
correct password into the device.
Access level: 1, 2, or 3.
Level-1 – User can add, change, and
display configuration options, save, and
perform device testing.
Level-2 – User can monitor and perform
diagnostics, display status and
configuration option information.
Level-3 – User can only monitor and
display status and configuration screens.
CAUTION: Make sure at least one login is set
up for Level-1 access or you may be
inadvertently locked out.
Security and Logins
in Chapter 6,
4-11