Adding Slv Alarms Manually - Paradyne FrameSaver SLV 9124 User Manual

Adding SLV Alarms Manually

9124-A2-GB20-00
Setting Up NetScout Manager Plus for FrameSaver Devices
Once DLCIs have been discovered, SLV alarms should be defined and assigned
to each DLCI.
When configuring alarms manually, every alarm must be configured for each
DLCI; that is, if there are eight alarms and 20 DLCIs, 160 trap configurations
must be created (8 x 20). For this reason, it is recommended that the OpenLane
defaults be used. Follow the procedure below to configure alarms manually.
To load OpenLane default settings for alarms, see
Template .
Procedure
1. From the NetScout Manager Plus main window, with the FrameRelay and
Admin radio buttons still selected, click on the Config Manager icon to open
the Configuration Manager main window.
2. Select the Custom radio button from the Properties File area (in the upper
right of the window), then Property... (down the center of the screen).
The Custom Property Editor window opens (see the window in
Alarms
).
3. Select a DLCI from the Trap list, and select the Add... button (to the right of
the list). The Add Trap window opens.
March 2000
Adding SLV Alarms Using a
Editing
8-11