Indicators, Controls, And Operation - Mircom FleXNet FNC-2000 Installation And Operation Manual

Indicators, Controls, and Operation

Refer to Figure 41 below for LED indicators, control buttons, and switches locations.
Figure 41: Indicators and Control Location
16 configurable
bi-coloured zone
indicators and 16
trouble indicators
Control and Indicators for Signal
Silence, General Alarm, Acknowledge,
Fire Drill, System Reset, Lamp Test
and Spare programmable Buttons
LED indicators are amber (trouble or supervisory), red (alarm), or green (AC On), and may illuminate continuously
(steady) or at one of two flash rates:
• Fast Flash: 120 flashes per minute, 50% duty cycle
• Trouble Flash: 20 flashes per minute, 50% duty cycle
Note: The General Alarm LED and pushbutton, and the Acknowledge LED and pushbutton, are active only
on a system configured for "Two Stage."
Paper Labels for Buttons and Indicators
Buttons and indicators are supplied with paper labels. These labels slide into the plastic label templates on the face
of the panel. Paper labels allow for easy English / French selection and custom-printed zone information.
Queue controls and
indicators for Alarm,
Supervisory,
Trouble and Monitor
TM
FleX-Net Installation and Operation Manual
AC On
Indicator
Cursor buttons
and Enter button
CPU Fault
Indicator
Ground Fault
Indicator
LCD Display
4 lines
20 characters
Menu
Cancel
Info
61