Mitsubishi Electric MELSERVO-J4 MR-J4 TM Instruction Manual page 42

1. FUNCTIONS AND CONFIGURATION
(c) MR-J4-500TM4
The broken line area is the same as
MR-J4-200TM4 or less.
(6)
(4)
(3)
(Note)
(5)
(1)
(2)
(7)
Note. Lines for slots around the battery holder are omitted from the illustration.
POINT
The servo amplifier is shown without the front cover. For removal of the front
cover, refer to section 1.7.2.
No. Name/Application
Control circuit terminal block (TE2)
(1)
Used to connect the control circuit power supply.
Main circuit terminal block (TE1)
(2)
Used to connect the input power supply,
regenerative option, and servo motor.
Battery holder
(3)
Install the battery for absolute position data backup.
(4) Rating plate
Power factor improving reactor terminal block (TE3)
(5)
Used to connect a power factor improving DC
reactor.
Charge lamp
(6) When the main circuit is charged, this will light.
While this lamp is lit, do not reconnect the cables.
Protective earth (PE) terminal
(7)
Grounding terminal
1 - 25
Detailed
explanation
Section 3.1
Section 3.3
Section
12.2
Section 1.6
Section 3.1
Section 3.3
Section 3.1
Section 3.3