Mitsubishi Electric MELSERVO-J4 MR-J4 TM Instruction Manual page 294

Multi-network interface ac servo amplifier

11. OPTIONS AND PERIPHERAL EQUIPMENT

11.1 Cable/connector sets

Please purchase the cable and connector options indicated in this section.

Before connecting any option or peripheral equipment, turn off the power and wait

for 15 minutes or more until the charge lamp turns off. Then, confirm that the

voltage between P+ and N- is safe with a voltage tester and others. Otherwise, an

electric shock may occur. In addition, when confirming whether the charge lamp is

off or not, always confirm it from the front of the servo amplifier.

Use the specified peripheral equipment and options to prevent a malfunction or a

We recommend using HIV wires to wire the servo amplifiers, options, and

peripheral equipment. Therefore, the recommended wire sizes may differ from

those used for the previous servo amplifiers.

The MR-J4-11KTM(4) to MR-J4-22KTM(4) will be available in the future.

The IP rating indicated for cables and connectors is their protection against

ingress of dust and raindrops when they are connected to a servo amplifier or

servo motor. If the IP rating of the cable, connector, servo amplifier and servo

motor vary, the overall IP rating depends on the lowest IP rating of all