Mitsubishi Electric MELSERVO-J4 MR-J4 TM Instruction Manual page 122

5. PARAMETERS
5. PARAMETERS
CAUTION
5.1 Parameter list
Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not set any values other than the described setting values to each parameter.
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: After setting the parameter, cycle the power or reset the network
communication.
**: After setting the parameter, cycle the power.
Abbreviations of operation modes indicate the followings.
Standard: Standard (semi closed loop system) use of the rotary servo motor
Full.: Fully closed loop system use of the rotary servo motor
Lin.: Linear servo motor use
DD: Direct drive (DD) motor use
5 - 1