Connecting To Ac Power; Turning On The Projector - Christie Roadie D4K40-RGB Installation And Setup Manual

7. To fine tune the focus, repeat steps 5 and 6 until optimum focus is achieved.

Connecting to AC power

Connect AC power to the projector.
1. Plug the AC power cord into the projector.
2. Secure the AC power cord with the power cord retainer.

Turning on the projector

When the projector AC power supply is plugged in and the breaker switch is on, the power is on.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
1. Plug the projector into AC power and turn on the breaker switch.
When plugged in and the breaker switch is on, the projector automatically powers on to
standby mode within 60 seconds. The display panel functionality becomes available.
2. To turn the light source on using the projector keypad, press and hold the Power
until you hear a beep.
To turn on the light source using the remote, press and hold the ON button until you hear a
beep.
D4K40-RGB Installation and Setup Guide
020-102961-06 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
button
28