Table of Contents
Advertisement
Electrical installation and operational guidelines
CAUTION
•
To be connected to Class 2 power source only
All Aventics communication nodes should be grounded during the installation process. These grounding guidelines can
•
be found in National Electrical code IEC 60204-1 or EN 60204-1.
All Aventics G3 Electronics Products to be installed or wired in accordance with Aventics's published instructions and
•
applicable electrical codes.
•
MULTIPLE CLASS 2 POWER SOURCES: When interconnects, class 2 sources shall be Listed and rated suitable for
parallel interconnection
•
Sources shall be Listed and rated suitable for parallel interconnection
CLASS 2 WIRING: All field wiring shall be suitable for Class 1, Electric Light and Power, or Class 2, 3 wirings are routed
•
separately and secured to maintain separation between 1) Class 2 wiring and all other class wiring, and 2) Limited
energy circuit conductors from unlimited energy circuit conductors
Class 2 Device Wiring Only – Do Not Reclassify and Install as Class 1, 3 or Power and Lighting Wiring
•
•
When using molded connector power cables, Do Not rely on wire colors for Pin-Out. Always use pin number
references.
Wire connections shall be rated suitable for the wire size (lead and building wiring) employed
•
•
MULTIPLE CLASS 2 POWER SOURCES: When interconnects, class 2 sources shall be Listed and rated suitable for
parallel interconnection
Sources shall be Listed and rated suitable for parallel interconnection
•
G3 Series PROFIBUS-DP
TDG3PTTM1-11EN
Subject to change without notice
www.asco.com
Technical Manual
TM
07/2020
2-3
Advertisement
Table of Contents
