Table of Contents
Advertisement
13.5
Profibus and G3 Diagnostics
The following example illustrates how to use the diagnostic capability within the PLC program. This example uses an
Aventics G3 Profibus Manifold, a Siemens S7-300 PLC and Siemens TIA Portal v15 programming software.
The G3 Manifold configured as a Profibus slave is shown in the network configuration
G3 Series PROFIBUS-DP
•
Profibus Node (240-239)
•
Valve driver interface module (219-828)
16 Point Input module (240-205)
•
Sub-bus module (240-241)
•
TDG3PTTM1-11EN
Subject to change without notice
TM
Technical Manual
07/2020
www.asco.com
13-121
Advertisement
Table of Contents
