Table of Contents
Advertisement
For this example, the G3 Profibus node diagnostic configuration must be set at the module
The Function Block RDSSYST (read system status list) is used to copy all available diagnostics into DB2 when
"Start" (bit m0.0) is on.
Command ID 00B4 hex=
Read slave diagnostics
Diagnostic address of G3 node=
1200 decimal = 04B0 hex.
G3 Series PROFIBUS-DP
ADVANCED
SETTINGS
ADVANCED MENU
SET EXT DIAG
EXT DIAG TYPE
DEVICE
TDG3PTTM1-11EN
Subject to change without notice
www.asco.com
TM
Technical Manual
Set Ext. Diagnostic Type to
Device
07/2020
13-124
Advertisement
Table of Contents
