Platform Rails Fold-Down Procedure (If Equipped) - JLG ES1932 Operation & Safety Manual

Machine Controls, Indicators, and Operation
3.13 PLATFORM RAILS FOLD-DOWN PROCEDURE (IF
EQUIPPED)
Only fold down the rails when the machine is in the stowed (platform fully lowered)
position. Do not raise the platform with the rails folded down. The rails must be in
the upright position and properly pinned when raising the platform.
The platform rails fold down from the mid-rail only, except for the rear gate rail.
3.13.1 Platform with Rail-in-Rail Extension Deck
The platform rails fold down in the following sequence (refer to
Fold-Down Sequence., page
1. Pull pin and fold REAR gate top rail in against RIGHT side rail. Remove the platform
control station and place on the floor of the platform.
Note: Front deck extension top rail pins must be removed and deck extension top
side rails slid towards rear of machine before lowering side rails. Place pins
in the lower holes of the extension side top rails before folding main plat-
form side rails down.
2. Fully open the swing gate and hold while folding down the RIGHT side rail.
3. Fold down LEFT side rail.
4. Fold down FRONT platform extension rail.
To raise the rails back to the upright position, unfold the rails in the reverse sequence
they were folded. Firmly pull the rails back up into position and replace the bail pins
into the rails.
After the rails have been folded down, use extreme caution when exiting and
entering the platform. Enter and exit platform only at the gate area and ladder
provided.
If driving machine with the platform control station from ground, do not hang the
control box on any part of the machine while driving. Hold the control box and
keep at least 3 ft (1 m) distance from machine.
50
WARNING
51):
WARNING
WARNING
31221541
Figure — Rail-in-Rail
ES1932, ES1932i