JLG ES1932 Operation & Safety Manual page 33

1. From the Ground Control Panel with no load in the platform:
a. Ensure that the key selector switch and the platform lift switch operates
properly.
b. Ensure that all machine functions are disabled when the Emergency Stop
Button is depressed.
c. With platform raised a few feet (1 m), ensure that the manual descent control
(T-handle located at the left rear of the machine, next to the battery charger)
lowers the platform properly.
d. Check that Pothole Protection system bars are fully lowered when the
platform is raised.
Platform Fully Lowered
Pothole Bars Raised
Platform Elevated
Pothole Bars Fully Lowered
2. From the Platform Control Console:
a. Ensure that the control console is firmly secured in the proper location.
b. Ensure that all guards protecting switches are in place.
c. Operate all switch functions, drive/lift mode select switch, and horn button.
d. Operate all platform joystick functions to ensure proper operation of drive,
lift, steer, and enable trigger switch operation.
e. Ensure that all machine functions are disabled when the platform Emergency
Stop Button is depressed.
f. Ensure all machine functions stop when function control is released or when
joystick trigger is released.
g. With the platform elevated on a smooth, firm, level surface with no overhead
obstructions, drive the machine to check if the high drive cutout speed limit
is engaged at the height indicated in
33. Ensure drive speed is reduced from a high speed to a slower speed.
MODEL
ES1932i
ES1932
ES1932, ES1932i
User Responsibilities, Machine Preparation, and Inspection
Table 4. High Drive Cutout Height
HIGH DRIVE SPEED CUTOUT
HEIGHT
67 in (1.7 m)
Table – High Drive Cutout Height, page
DRIVE SPEED REDUCTION
3.0 mph (4.8 kph) to 0.5 mph (0.8 kph)
31221541
33