JLG ES1932 Operation & Safety Manual page 97

The safety prop must be used whenever maintenance performed on the machine
requires the scissor arms to be raised and only with no load in the platform
The safety prop is located on the side of the scissor arms on the right side of the
machine.
To engage the safety prop:
1. From the Ground Control Station, raise the platform far enough to allow the safety
prop to be engaged.
2. Rotate the prop assembly clockwise until it hangs vertically on the side of the
scissor arms.
3. Lower the platform until the prop rests against the prop stop on the arm set
below it, stopping all downward movement of the platform/scissor arm assembly.
4. Turn off machine power by pressing the emergency stop switch at the Ground
Control Station.
To disengage the safety prop:
1. Pull out the emergency stop switch at the ground and raise the platform enough
to release the prop off the prop stop.
2. Rotate the prop assembly counterclockwise until it is resting on the arm prop
holder plate on the side of the scissor arm assembly.
ES1932, ES1932i
Machine Specifications and Operator Maintenance
CAUTION
31221541
97