JLG ES1932 Operation & Safety Manual page 81

Maximum weight in racks is 45 kg (100 lb) evenly distributed between racks. Max
length is 6 m (20 ft). Max circumference of material is 180 mm per pipe.
• Do not exit platform over rails or stand on rails.
• Do not drive the machine without material secured.
• Use this accessory on approved models only.
• Return racks to the stowed position when not in use.
5.9.2 Preparation and Inspection
• Ensure both racks are mounted and securely fastened to inside of platform rails.
• Check for missing or damaged components. Replace if necessary.
5.9.3 Operation
1. To prepare racks for loading, remove locking pins, rotate each rack 90 degrees
from stowed to working position, then secure with locking pins.
2. Place material onto racks with weight evenly distributed between both racks. Do
not exceed the rated capacity stated on the decal.
3. Route the tie-down straps at each end across loaded material and tighten.
4. To remove material, loosen and remove tie-down straps, then carefully remove
material from racks.
Note: Reinstall tie-down straps across any remaining material before continuing
machine operations.
5. When not in use, remove locking pins, rotate racks 90 degrees to the stowed
position, then secure locking pins.
ES1932, ES1932i
NOTICE
31221541
Accessories
81