Platform Rails - Fold-Down Procedure - JLG RT3394 Operation & Safety Manual

2. With the engine under a no load condition, open the hand valve on the LPG
supply tank by turning counterclockwise.
3. While the engine is operating, place the two position LPG/gas select switch at the
platform control station to LPG.
3.14.2 Changing from LPG to Gasoline
1. With the engine operating on LPG under a no load condition, position the LPG/
gas select switch at the platform station to the gas select position.
2. If the engine 'stumbles' because of a lack of gasoline, place the switch to the LPG
position until the engine regains smoothness, then return the switch to the gas
select position. Repeat as necessary until the engine runs smoothly on gasoline.
3. Close the hand valve on the LPG supply tank by turning clockwise.

3.15 PLATFORM RAILS - FOLD-DOWN PROCEDURE

Refer to Figure — Platform End Rails - Fold Down Sequence and Rail Pin Locations, page 56
and Figure — Platform Side Rails - Fold Down Sequence and Rail Pin Locations, page 57
fold-down procedure illustrations.
Only fold down the rails when the machine is in the stowed (platform fully lowered)
position. Do not raise the platform with the rails folded down. The rails must be in
the upright position and properly pinned when raising the platform.
The platform end rails fold-down first. If platform is equipped with one or more
platforms extension(s), both the main platform side rails and the extension platform side
rails will be folded down together.
1. Remove the platform control box and place it on the platform deck. On both sides
of machine, open swing gate and remove the pin on swing gate kick-plate to
allow fold down later.
2. Pull platform end rail pins (two pins per end rail, see short arrows in
Platform End Rails - Fold Down Sequence and Rail Pin Locations, page
the platform end rails down onto the platform deck.
3. Pull platform extension side rail pins (one per rail set, see short arrows in
Platform Side Rails - Fold Down Sequence and Rail Pin Locations, page
down extension side rails.
4. Pull main platform side rail pins (four per rail set, see short arrows in
Platform Side Rails - Fold Down Sequence and Rail Pin Locations, page
down main platform side rails.
5. To raise the rails back to the upright position, unfold the rails in the reverse
sequence they were folded. Firmly pull the rails back up into position and replace
the rail pins into the rails.
RT3394, RT4394
Machine Controls, Indicators, and Operation
WARNING
31221544
for
Figure —
56) and fold
Figure —
57), then fold
Figure —
57), then fold
55