Ground Control Station - JLG ES1932 Operation & Safety Manual

Machine Controls, Indicators, and Operation
1. Connect the charger AC input plug to a grounded outlet using a 3 wire heavy
duty extension cord.
2. After connecting the charger to an AC outlet at the start of the charging cycle,
verify normal operation of the LED indicators on the charger (refer to
Operator Maintenance).
Note: Current battery charge state can also be seen on the platform control sta-
tion panel LEDs or the MDI indicator (if equipped) on the ground control
station when machine is powered up.
3. The batteries are fully charged when all three GREEN LED indicators on the
platform control station or MDI battery charger status panel are illuminated.
Note: If the charger is left plugged in, the charger will automatically restart a com-
plete charge cycle if the battery voltage drops below a minimum voltage, or
if 30 days has elapsed.
3.7

GROUND CONTROL STATION

1. Ground/Platform/OFF Key Selector Switch
2. Platform Lift/Lower Switch
3. Inverter ON/OFF Switch (If Equipped)
4. Ground Emergency Stop Button
38
5. Hourmeter
6. Overload Indicator
7. MDI Indicator (If Equipped)
31221541
O N
Section —
SC000100A
ES1932, ES1932i