JLG ES1932 Operation & Safety Manual page 45

Steering And Traveling
1. Place key selector switch at the ground control station to platform operation.
2. Position emergency stop switches, one at the platform and one at the ground control station to the ON
position.
Do not drive with platform raised except on a smooth, firm surface, within the limits
of the maximum operating slope, free of obstructions and holes.
To avoid loss of travel control or upset on grades and side slopes, do not drive
machine on grades or side slopes exceeding those specified in Section 6.
Before driving, locate the decals with the black/white orientation arrows on the
chassis and the platform controls. Move the joystick in the direction of the black or
white arrow that matches the color of the arrow on the chassis for the intended
direction of travel.
If the tilt indicator warning light/alarm is activated while driving with platform
raised, lower platform completely and drive to a smooth, firm surface, within the
limits of the maximum operating slope.
System Fault Indicator
When this indicator light is flashing, a system fault has occurred, possibly stopping
machine operation.
Check the MDI Indicator (if equipped) on the Ground Control Station to see if a DTC is
displayed.
If the code cannot be cleared by the operator, the machine will require service by a
qualified JLG mechanic.
Tilt Indicator Warning Light and Alarm
A red warning light on the control panel illuminates and an audible alarm sounds when
the chassis is at or beyond the tilt cutout settings.
If the tilt indicator warning light/alarm is activated when platform is raised, lower
platform and drive to a smooth, firm surface, within the limits of the maximum
operating slope.
ES1932, ES1932i
Machine Controls, Indicators, and Operation
WARNING
WARNING
31221541
45