Walk-Around Inspection - JLG ES1932 Operation & Safety Manual

2.4

WALK-AROUND INSPECTION

2.4.1 General
Begin the Walk-Around Inspection at Item 1, as noted on the diagram. Continue
checking each item in sequence for the conditions listed in the following checklist.
To avoid possible injury, be sure machine power is off. Do not operate machine
until all malfunctions have been corrected.
Do not overlook visual inspection of chassis underside. Checking this area may
result in discovery of conditions which could cause extensive machine damage.
INSPECTION NOTE: On all components, make sure there are no loose or missing parts,
all parts are securely fastened, and no visible damage, leaks, or excessive wear exists in
addition to any other criteria mentioned.
1. Frame/Chassis/Ladder – See Inspection Note. Ensure that pothole protection
(PHP) components on frame are in place, undamaged, not bent or worn. Side
compartment doors open and close properly.
ES1932, ES1932i
User Responsibilities, Machine Preparation, and Inspection
WARNING
NOTICE
31221541
31