Table of Contents
Advertisement
User Responsibilities, Machine Preparation, and Inspection
9. Function Check — Once the Walk-Around Inspection is complete, perform a
functional check of all systems in an area free of overhead and ground level
obstructions. Refer to Section 4, Machine Operation for more specific instructions.
10. Platform Gate — Keep gate and surrounding area clean and unobstructed. Verify
the gate closes properly and is not bent or damaged. Keep gate closed at all times
except when entering/exiting the platform and loading/unloading materials.
11. Lanyard Attach Points — During operation, occupants in the platform must wear
a full body harness with a lanyard attached to an authorized lanyard anchorage
point. Attach only one (1) lanyard per lanyard anchorage point.
If the machine does not operate properly, turn off the machine immediately! Report
the problem to the proper maintenance personnel. Do not operate the machine
until it is declared safe for operation.
2.5
WALK-AROUND INSPECTION
7
13
14
5
14
5
7
Begin the Walk-Around Inspection at Item 1, as noted on the diagram. Continue
checking each item in sequence for the conditions listed in the following checklist.
30
WARNING
8
11
10
12
9
9
15
8
31219187
7
6
5
6
5
16
5
7
2
4
3
OAC03330
1
EC450AJ, EC520AJ
Advertisement
Table of Contents
