Table of Contents
Advertisement
User Responsibilities, Machine Preparation, and Inspection
2.4
WALK-AROUND INSPECTION
Begin the Walk-Around Inspection at Item 1 as noted on the diagram. Continue to the
right (counterclockwise viewed from top) checking each item in sequence for the
conditions listed in the following checklist.
To avoid possible injury, be sure machine power is "OFF" during walkaround
inspection.
Do not overlook visual inspection of chassis underside. Checking this area often
results in discovery of conditions which could cause extensive machine damage.
INSPECTION NOTE: On each item, make sure there are no loose or missing parts, that
they are securely fastened, and that no visible damage exists in addition to any other
criteria mentioned.
1. Oscillating Axle Tilt Sensor – No unsupported wires; no damaged or broken
wires - See Inspection Note.
2. Steer Cylinder – See Inspection Note.
3. Spindle, Tie Rod, and Steer Linkage – See Inspection Note.
4. Wheels and Tires – Properly secured, no missing lug nuts (refer to
and
Wheels). Inspect wheels for damage and corrosion.
5. Wheel Drive Hub – See Inspection Note.
30
WARNING
NOTICE
31221544
Section — Tires
RT3394, RT4394
Advertisement
Table of Contents
