Advertisement
11.8.5
Return-to-origin on all axes
This section explains how to perform return-to-origin on all axes specified by the controller.
The robot must be at servo-on to perform return-to-origin on incremental mode axes using
the stroke end detection method or sensor method for return-to-origin. Likewise, the robot
must be at servo-on to perform an absolute search on semi-absolute mode axes.
[Procedure]
c
CAUTION
Before performing return-to-origin, check that all axes are in positions that
allow return-to-origin operation.
1) In "MANUAL>ORIGIN" mode, press
A confirmation message appears on the guide line in the programming box screen.
Press
(YES) to perform return-to-origin on all axes.
Press
(NO) to cancel return-to-origin on all axes.
■ Return-to-origin on all axes (1)
MANUAL>ORIGIN>ALL
Origin return again?
w
WARNING
THE ROBOT STARTS MOVING AS SOON AS RETURN-TO-ORIGIN IS PERFORMED.
TO AVOID HAZARDOUS SITUATIONS, DO NOT ENTER THE ROBOT MOVEMENT
RANGE.
2) After return-to-origin (absolute search on semi-absolute mode axes) is complete, the
machine references on all axes are displayed.
■ Return-to-origin on all axes (2)
MANUAL>ORIGIN
Machine reference (%)
M1=
M1
M2
50%[MG][S0H0J]
YES
50%[MG][S0H0J]
50 M2=
50
M3
M4
11. "MANUAL" mode
(ALL) to perform return-to-origin on all axes.
NO
M5
Chapter
4
4-143
Advertisement
Chapters
