Table of Contents
Advertisement
5.10.2.2
External Lights 1, 2 and 3
Press <enter> to display the Light 1 setting. Figure 5- 12)
Press <enter> again to select from the 5 Charger states of operation.
Use the <up> and <down> buttons to choose the charger state you wish to monitor.
Once the desired state is displayed, press <enter> to store the edited value.
Press <clear> to exit.
5.10.3 EQ Button Action
The EQ Button Action menu is used to configure the actions of the front panel EQ button. The
three valid configurations are:
1. ALWAYS_ACTIVE – The EQ button is always active.
2. DISABLED – The EQ button is disabled.
3. WORKS_ON_EQ_DAY_ONLY – The EQ button works on scheduled EQ day only.
EQ Button Action
Configuration
EQ Button Action:
CLEAR
Always Active
EQ Button Action:
WORKS ON EQ DAY ONLY
EQ Button Action:
Disabled
The EQ button is made configurable so that the charger may be configured to prevent untrained
or unauthorized users from causing excessive equalization activity by pressing the EQ button
when an EQ is not required.
5.10.3.1
Setting the EQ Button Action
From the "EQ Button Action" screen, press <enter> to display the current EQ button
configuration. Press <enter> again and the programmable parameter will flash. Use the <up>
and <down> buttons to toggle parameters. The display will continue to flash until you press
<enter> to set the displayed parameter. Press <clear> to exit.
DISABLED - This setting causes the charger to ignore the EQ button.
ALWAYS ACTIVE - This is the default setting and causes the EQ button to be active at all
times.
WORKS ON EQ DAY ONLY - This setting causes the EQ button to function only on the day of
the week programmed in the BMID for equalization.
23435-W-03-01
SVS100 Installation, Operation and Maintenance Manual
ENTER
ENTER
Figure 5- 13 EQ Button Action
36
Charger Configuration
CLEAR
ENTER
Press ENTER to accept the selection made.
After pressing ENTER, press CLEAR to retain
the original value.
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
