Table of Contents
Advertisement
3
Safety
3.1
General information
The device must only be used in a technically faultless condition.
Any malfunctions that adversely affect the safety of persons or
of the device must be immediately rectified by a qualified elec-
trician in accordance with nationally applicable regulations.
3.2
General safety information
WARNING
l Hazardous voltages are present within the casing.
l The charging station does not have its own main ON/
OFF switch. The protective devices installed in the
power supply system are therefore also used to discon-
nect the power supply.
l Check charging station for visual damage before use.
Do not use the charging station if damaged.
l Installation, electrical connection and initial operation
of the charging station must only be carried out by an
electrician.
l Do not remove the cover of the installation area whilst
in operation.
l Do not remove markings, warning symbols and the
type label from the charging station.
l It is strictly prohibited to connect other equipment/
devices to the charging station.
l Make sure that the charging cable and coupling can-
not be driven over, trapped and are protected from
any other hazards.
l Immediately notify Webasto Customer Service if the
charging station, charging cable or the charging coup-
ling are damaged. Do not continue using the charging
station.
l Prevent the charging cable and coupling from coming
in contact with external heat sources, water, dirt and
chemicals.
l Do not attach extension cables or adapters to the char-
ging cable.
l Remove the charging cable by pulling on the charging
coupling only.
l Never clean the charging station with a high-pressure
cleaner or similar device or using a garden hose.
l Switch off the power supply before cleaning the char-
ging sockets.
l The charging cable must not be subjected to any strain
during use.
l Ensure only persons who have read these operating in-
structions have access to the charging station.
WARNING
l When not in use, store the charging cable in the desig-
nated holder and lock the charging coupling in the re-
mote dock. Loosely wind the charging cable around
the remote dock making sure the cable does not touch
the floor.
l You must make sure that the charging cable and coup-
ling cannot be driven over, trapped and are protected
from all other hazards.
5111967A OI-II Webasto Unite
3.3
Safety information for installation
WARNING
l The instructions in this document must be followed for
safe installation.
l Installation and connection of the charging station
must only be carried out by a qualified electrician.
l You must comply with the locally applicable require-
ments regarding electrical installations, fire protection,
safety regulations, and escape routes at the intended
installation location.
l Only use the supplied installation material.
l When open, ESD (electrostatic discharge) precautions
must be taken properly to avoid electrostatic dis-
charge.
l When handling electrostatically sensitive boards, wear
grounded antistatic wrist straps and properly observe
ESD safety precautions. Wrist straps must only be used
when mounting and connecting the loading unit. Wrist
straps must never be worn on a live Webasto Unite.
l Electricians must be properly grounded during installa-
tion of the Webasto Unite.
l Do not install the Webasto Unite in an explosion sens-
itive area (Ex Zone).
l Install the Webasto Unite in such a way that the char-
ging cable does not block any passageways.
l Do not install the Webasto Unite in areas subject to
ammonia or air containing ammonia.
l Do not install the Webasto Unite in a location where
falling objects may damage it.
l The Webasto Unite is suitable for use indoors as well
as outdoors.
l Do not install the Webasto Unite in the vicinity of wa-
ter jets, such as car-wash installations, high-pressure
cleaners or garden hoses.
l Protect the Webasto Unite against damage caused by
sub-zero temperatures, hail or similar. We would like
to refer you to our IP protection class at this juncture
(IP54).
l The Webasto Unite is suitable for use in areas without
access restrictions.
l Protect the Webasto Unite from direct sunlight. The
charging current may be reduced at high temperat-
ures, or charging may be disabled completely.
The operating temperature is -35°C to +55°C.
l The installation location of the Webasto Unite should
ensure that vehicles cannot inadvertently collide with
it. Protective measures must be implemented if the
possibility of damage cannot be ruled out.
l Do not put the Webasto Unite into operation if it has
been damaged during installation; a replacement will
be required.
Safety | 3
5 / 37
Advertisement
Table of Contents
