11. Stand-alone Option for RC520
This section describes a Stand-alone Option that allows you to use the RC520's Control
Unit only.
11.1 Stand-alone Option
A Stand-alone Option allows forming the Control Unit own system including the
Emergency Stop input and Safety Door input by connecting an Emergency Connector
Plate Kit to the Control Unit.
NOTE
The Stand-alone Option is available in SPEL CT or higher and EPSON RC+ Ver.3.6 or
higher.
If necessary, refer to the Setup & Operation 2.4 Control Unit for functions of the Control
Unit.
11.2 System Configuration
11.3 Installation
When installing the Control Unit, it must be placed in the proper environment.
For details, refer to the Setup & Operation 3. Installation.
RC520 Rev.7
Setup & Operation 11. Stand-alone Option for RC520
Control Unit
OP500
Sensor
Camera
Solenoid Valve
Driver
Motor
107