Mib; Board Number; Jumper Settings - Epson RC520 Manual

11.6 MIB

11.6.1 Board Number

When using the Control Unit only, use the MIB with the following board number.
SKP372-1 Dr-04
SKP372-2 Dr-04
SKP372-3 or later

11.6.2 Jumper Settings

Set the MIB jumper referring to the table below.
When the board number is SKP372-3 or later, JP1, JP6, and JP7 do not exist on the
board.
Jumper
JP1
JP2
JP3
JP4
JP5
JP6
JP7
JP8
JP9
JP10
JP11
For jumper functions, refer to the Setup & Operation 10. Jumper Settings for MIB.
11.7 Option
The options for RC520, such as the Operation Units (JP500 and OP500), Expansion I/O
Board and Pulse Generating Board, are available to use even in the Control Unit system
only.
For details, refer to the proper section in this manual or the manual for each option.
RC520 Rev.7
Setup & Operation 11. Stand-alone Option for RC520
Setting
1-2, 3-4 short
3-4 short
1-2 short
All open
1-2, 3-4, 5-6 short
1-2 short
1-2 short
All open
1-2 short
1-2 short
All open
Note
Interrupt level: IRQ10
Interrupt level: IRQ5
Memory address: D8000-DFFF
I/O address: 300-31F
113