Table of Contents
Advertisement
Maintenance 2. Regular Maintenance Inspection
(5) The following message dialog will appear when the data is completely backed up.
Restoring the Hardware & Manipulator Backup File
(1) If a project backup file must be restored as well as the system's hardware or
(2) Be sure of the folder/disk to restore.
(3) Close all projects that are open.
(4) Select the [Setup] - [Restore] - [System] commands.
(5) Select the folder to restore. Click the <OK> button.
130
If there are any other files found in the specified folder, the following message dialog
will appear. Click the <Yes> button if it is okay to delete the existing file. Click
the <No> button to cancel saving the backup.
The status bar will indicate the system's status while a backup file is being saved.
Click the <OK> button.
manipulator settings backup file, restore the project file first.
"Restoring Projects" in the later part of this section.
Refer to the
RC520 Rev.7
Advertisement
Table of Contents
