CAUTION:
CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
Procedure
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
5. Remove the access panel .
6. Remove all LFF drives .
7. Disconnect all cables from the 4 LFF drive backplane .
8. Remove the 4 LFF drive backplane:
a. Press and hold the release latch (callout 1).
b. Hold the drive backplane at the ends and detach it from the drive cage (callout 2).
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide
59