Results
Results
To replace the component, reverse the removal procedure.
Removing and replacing the Media Module adapter
Removing and replacing the Media Module adapter
Prerequisites
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
Procedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
7. Remove the access panel .
8. Remove the primary PCI riser cage.
9. Remove the Media Module adapter screws.
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide
70