HPE ProLiant DL160 Gen10 Maintenance And Service Manual page 41

Removing the primary PCI riser cage Removing the primary PCI riser cage
About this task About this task
CAUTION: CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all AC power cords
before removing or installing the PCI riser cage.
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
Procedure Procedure
1. Back up all server data.
2. If installed, remove the bezel.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
6. Remove the access panel .
7. Remove the PCI riser cage.
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 41