Results
Results
To replace the component, reverse the removal procedure.
Removing and replacing the energy pack and holder
Removing and replacing the energy pack and holder
Procedure
Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel .
6. Disconnect the cable and then remove the energy pack.
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide
77