HPE ProLiant DL160 Gen10 Maintenance And Service Manual page 62

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the 2 SFF drive backplane Removing and replacing the 2 SFF drive backplane
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this task About this task
CAUTION: CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
Procedure Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 62