HPE ProLiant DL160 Gen10 Maintenance And Service Manual page 81

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the SFF front I/O assembly Removing and replacing the SFF front I/O assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
About this task About this task
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Procedure Procedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Do one of the following:
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 81