HPE ProLiant DL160 Gen10 Maintenance And Service Manual page 69

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the FlexibleLOM adapter Removing and replacing the FlexibleLOM adapter
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
7. Remove the access panel .
8. If necessary, disconnect any internal cables connected to the system board.
9. Remove the primary PCI riser cage.
10. Remove the FlexibleLOM adapter.
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 69