HPE ProLiant DL160 Gen10 Maintenance And Service Manual page 68

1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel .
6. Remove the right DIMM guard.
7. To replace the left DIMM guard, do the following:
a. If installed, remove the chassis intrusion detection switch .
b. Remove the left DIMM guard.
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 68