HPE ProLiant DL160 Gen10 Maintenance And Service Manual page 84

Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the chassis intrusion detection switch Removing and replacing the chassis intrusion detection switch
Procedure Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel .
6. Remove the chassis intrusion detection switch..
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 84