HPE ProLiant DL160 Gen10 Maintenance And Service Manual page 67

Removing and replacing a DIMM Removing and replacing a DIMM
Prerequisites Prerequisites
Before replacing memory, read the memory configuration and population guidelines in the server user guide.
Procedure Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel .
6. Remove the DIMM.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the DIMM guards Removing and replacing the DIMM guards
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
HPE ProLiant DL160 Gen10 Server Maintenance and Service Guide 67