Loudspeaker Cables - Cisco Webex Room Panorama Installation Manual

13.1 Loudspeaker cables

1. Connect cable bundles A1 (left) and
the diagram.
2. Attach the cables to the hooks above the amplifier with velcro.
3. Leave ends marked S1-S6 and S7-S12 on top of the cavities:
• S1-S6 to the left
• S7-S12 to the right
4. Hang ends marked SB1-SB4 down behind the rack cavity, and
them to the subwoofers.
• SB1-SB2 to the left
• SB3-SB4 to the right
SB1 SB2
5. Fasten the subwoofer cables to the bottom of the display cavities with
velcro to prevent the cables and connectors from touching the subwoofers.
Touching the subwoofers may cause rattling noise.
13.2 Power cable for the Ethernet switch
1. Connect the power cable (X4) to the Ethernet switch.
The power socket is facing downward, so you have to connect it from
below.
2. Lead the cable through the hole toward the right power cavity.
Don't connect it to the socket outlet now.
3. Fasten the cable to the bottom of the display cavity with velcro to prevent
the cable from touching the subwoofers and cause rattling noise.
C6
A2 (right) to the amplifier as shown in
SB3 SB4
C7
13.3 PSUs for the amplifier
1. Place the two PSUs in the bracket in the left power cavity.
connect
2. Lead the cables on top of the cavities and connect the two PSUs to the
amplifier as shown in the wiring diagram (D2, D3).
3. The 24 V PSU (the largest one) has a power switch. Switch it to ON.
4. Connect the power cords to the PSUs (D4, D5). Don't connect them to the
socket outlets now.
13.4 Samsung One Connect cable
The Samsung One Connect cables are shipped with the screens. They lay in
the foam on top of the screen.
These cables are fragile, take care not to pinch or bend them.
1. Connect a cable to each Samsung One Connect box.
2. Bundle excess cable carefully, thread it behind the screen bracket and hang
it in the display cavity.
Leave about 1 meter (40 in.) of cable for the screen. It will be connected
later.
C6 C7
D3 D4
29