Vulcan-Hart VHG-C Series Operation Manual page 5

VHG SERIES GAS FRYERS

Twin Fry Baskets (2) per fry tank

Cleanout Rod

Fryer Batteries with the KleenScreen PLUS® Filtration System
• Filter Pan
• Suction Tube
• Screen Assembly
• High temperature discard hose
• Crumb Basket
• Manual, Quick Start Guide(s), and Warranty-Keep in safe place for reference
Do not use the door or its handle to lift the fryer.
Before installing the fryer, verify that the type of gas (natural or propane) agrees with the
specifications on the fryer data plate, which is located on the inside of the door panel.
Make sure the fryer is configured for the proper elevation.
Record your fryer model, device, and serial numbers for future reference in the space
provided below. This information can be found on the fryer data plate.
Fryer Model No: ___________________________
Device: ___________________________________
Serial No: ________________________________
Clearances

Minimum clearance from combustible construction:
6" (15 cm) from the sides of the fryer
6" (15 cm) from the back of the fryer
The fryer may be installed on combustible floors

Minimum clearance from noncombustible construction:
0" from the sides of the fryer
0" from the back of the fryer

Between the fryer and any open-top flame units:
16" (41 cm)

Allow space for servicing and operation.
Some service procedures will require removal of side panels or access to rear of the
unit.
VULCAN
INSTALLATION
-5-
F-47678 Rev. A (3-20)