Vulcan-Hart VHG-C Series Operation Manual page 33

VHG SERIES GAS FRYERS
If discard vessel is not large enough to hold the entire shortening amount, stop the flow by pushing the filter
button to to turn the motor/pumpoff. Empty the container and resume discard operation by pressing the filter holding for 3-4
seconds.
If power is mistakenly turned off during the filtering operation, the corrective action is as follows.
1. Close the drain valve
2. Turn the power switch on
3. Immediately open drain valve
4. Continue filtering operation
FILTERING TIP:
Open the filtering drawer approximately 1" to allow any oil in the return line to run back into the filter pan. This will take about
30 seconds to complete. Then open the drawer completely to clean filter components.
REMOVING EXCESS DEBRIS FROM THE SCREEN FILTER:
Hot oil and hot parts can cause burns.
Never run water or boil out solution through filter and motor / pump. Doing so will void
your fryer warranty.
Filter ONLY one fry tank at a time to avoid overflow and spillage.
Open the filtering drawer approximately 1" to allow any oil in the return line to run back into the filter
pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter
components.
1. Pull the filter drawer out.
2. Remove the filter screen assembly. Scrape debris from the filter screen. Then remove the
insert by unlatching the latch. Clean all parts thoroughly as mentioned in the assembly
section on page 24.
3. Scrape debris from the bottom of the filter pan and discard in the trash. Clean all parts
thoroughly as mentioned in the Assembly section on page 24.
4. Reassemble all filter components after being dried thoroughly as in the assembly section on
page 24.
VULCAN
FILTERING TIP:
-33-
F-47678 Rev. A (3-20)