Vulcan-Hart VHG-C Series Operation Manual page 21

VHG SERIES GAS FRYERS
10. Press the 2 button on the right button set timer keypad, USB OPTION displays. Press UP and DOWN on the
PROGRAM button to select COPY FROM(to download a recipe menu from a drive), select COPY TO(to upload a
recipe menu to a drive) or EXIT. Press CONFIRM
a. Display will show COPY RECIPE FROM(or TO) USB?. Press the CONFIRM
11. Press the 4 button on the right button set timer
pad, SERIAL displays. This is the controller serial number
and is not a programmable parameter.
Computer Control Timer Operation
1. Press the desired numbered timer button(s) to
activate.
2. The timer light will flash and the timer will begin
countdown.
5. Press timer button to silence alarm when time
completes.
Note : The two timers with the least amount of remaining time will display when more than two timers are running
simultaneously.The light for the timer with the least amount of remaining time will flash faster.
Note : The timer will only activate when the control displays READY. If the temperature is too low, the control displays
HEATING and will display READY again once back up to temperature.
VULCAN
button.
12. Press the 9
pad, LOAD FACTORY DEFAULTS? displays. Press UP and
DOWN on the PROGRAM
N(NO). Select Y and press CONFIRM
the controller to the factory setpoints or N to leave
inactive.
3. Press and release timer button to briefly display the
corresponding recipe name.
4. Press and hold desired timer button for 3 seconds to
cancel a cook timer.
6. Timers with time remaining will continue to run.
-21-
button to copy a menu.
button on the right button set timer
button to select Y(YES) or
button to reset
F-47678 Rev. A (3-20)